

Submerge in IPA instead. It’s less likely to damage the watch further. Or just go outside and put on a respirator :)
(after you remove the pallet fork, that is, that’s the only part that can be damaged by IPA)


Submerge in IPA instead. It’s less likely to damage the watch further. Or just go outside and put on a respirator :)
(after you remove the pallet fork, that is, that’s the only part that can be damaged by IPA)


I have a decent Geiger counter these days (well, technically a dosimeter) for that. But in case of doubt, my recommendation is to submerge the dial in IPA, use Q-tips to wipe off the lume, flush IPA and double-wrap Q-tips before they dry then in the trash. It’s quick and safe that way and you probably want to relume anyway.
My absolutely not-fake Rolex has an acrylic crystal and it scratches up like there’s no tomorrow. Not a guarantee in general, therefore (dunno about this specific model, though)
You should see my Rolex 😂
If it’s acrylic, Polywatch will take care of that in a jiffy.


Is that 285 under the Omega sign on the movement? Calibre 285 from 1952 according to the serial number. That’s gonna be a heck of a restoration job :)


You’re probably not wrong, but there’s a difference between stumbling upon it in 2026 and pulling that off in 1958 :-)


Scheme has a chapter, after all it’s just Lisp. I think - I hope - that some pretty foundational stuff is treated throughout the book.


Yes you do! ;-)


Thanks! Clojure is a great example of a modern Lisp. Common Lisp is the Swiss army knife of programming and used everywhere you care to look, that is if you look hard ;)
While I won’t say that writing a text editor or rewriting (base) Emacs is easy, I think it is all about the ecosystem. There’s lots of Emacs reimplementations out there, some really good ones (like Lem), but they all have the same shortcoming: “no org mode”, “no magit”, and so on.
Emacs has a truly enormous ecosystem and only a reimplementation that runs everything unchanged has a chance of attracting enough attention. There was a time that that was seen as a worthwhile venture: Elisp was limited and slow. However, now with CL compatibilty and native compilation, I don’t see it happening. Not in the sense of something standing up that can and will actually replace Emacs.
Worse is better :-)


It’s just much easier to stop using them. Remember: its founder and largest shareholder (I guess) was one of the billionaire groupies standing behind Trumd during his inauguration. Canadians should not be shopping on Amazon.
I’ve never seen IPA put anything but fats and greases into solution. I like IPA because it’s hardly a stronger solvent than water (do not estimate how strong a polar solvent especially distilled/demineralized water is!) and no risk of corrosion.