• 3 Posts
  • 9 Comments
Joined 3 évvel ezelőtt
cake
Cake day: 2023. július 19.

help-circle
  • Hey! Really not my cup of tea, but here’s a few comments:

    • what are the input outputs? Are you powering 6 lasers at the same time? Why hook it up to an arduino? How are the lasers connected? What is a good representative load for your laser (probably resistive, but maybe inductive or capacitive?)
    • Looking at the driving circuit, there’s something fishy about them. Having a variable Vi and static ADJ pin is not what I would have expected, nor what the datasheet suggests
    • how about providing a fixed, appropriate voltage on the + terminal of your laser and have low side switching through a mosfet?
    • components seem pretty basic, you could probably simulate this throught spice to get a better idea of what’s happening (you can prob do this directly in kicad). Be careful about choosing models for stuff outside the PCB like the lasers. Long cables can have significant capacitive load for example.

    EDIT: I think the gist of the problem is that (1) the LM317 is powered on and off continusly, causing transients, power on delays,… (2) the adjust pin depends on the voltage on the output pin, potentially causing more resonance/weird transients. I would: stick to the suggested circuit in the datasheet of the lm317, and move the switching transistor between the lm317 and the laser.




  • I believe it does. Weakly reciprocal license like LGPL is not equivalent as a permissive license like Apache. I see two main things on the top of my head:

    1. This ensure that no one can license wash ffmpg and e.g. use rockchip’s repo to distribute their own private product based on ffmpeg without publishing their changes
    2. It ensures proper attribution of the work, which can have an impact on the developer’s careers and ffmpeg as a whole.

    On top of this, it really should not be complicated to license this code properly (unless rockchip wants to allow point 1, which is illegal)



  • The fact that a capacitor is marked with a 1000V label does not necessarily mean that 1000V are present on its terminal (but you should use caution). I don’t think the voltage makes it out of the realm of electronics.

    It’s quite hard to answer your question, as the board is quite dirty and you provided a single picture. You could check for continuity and capacitance value with a multimeter





  • We are working towards having a product properly packaged. This is a prototype that is not mature enough yet to justify the cost/time to package it. Moreover, this custom chip is used to measure ultra low currents (down to femto amps), so any packaging could potentially interfere with the measurement capabilities (-> no epoxy). It is however protected by a large shielding box, but it’s no use during assembly/modifications :/